3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
3D Printers/FlashForge Creator Pro (view source)
Revision as of 19:01, 16 April 2017
, 16 April 2017→Usage
(→Usage) |
|||
| Line 29: | Line 29: | ||
Detailed instructions are here -- http://data.flamy.ca/printer_config/doc/cretor_pro_config.html | Detailed instructions are here -- http://data.flamy.ca/printer_config/doc/cretor_pro_config.html | ||
It is still possible to use makerbot software, just generate an .x3g file instead of .gcode and upload it to octoprint | It is still possible to use makerbot software, just generate an .x3g file instead of .gcode and upload it to octoprint. | ||
It is still possible to use cura, just edit and save your models with STL, then load them into Slic3r and print | |||
==Slic3r Settings== | ==Slic3r Settings== | ||