111
edits
Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Status
(→Status: Update for not square/round.) |
(→Status) |
||
| Line 6: | Line 6: | ||
==Status== | ==Status== | ||
<onlyinclude> | <onlyinclude> | ||
*'''Last known good settings''': ( | *'''Last known good settings''': (01-Sept-2017, Pink PLA) '''220°''', 135% flow, print @ '''60mm/s''' (full speed), travel @ '''150mm/s''' (full speed), 0.4 mm nozzle size, 2.85mm filament size. (got a pretty good print) <all it needed was the right extrusion...> | ||
* Operational ... it can be '''Problematic''' | * Operational ... it can be '''Problematic''' | ||
** Using a Brim to hold parts to the Print Bed is strongly recommended. | ** Using a Brim to hold parts to the Print Bed is strongly recommended. | ||