Type A: Difference between revisions
Jump to navigation
Jump to search
→Recommended Filament Settings: update based on use
(→Recommended Filament Settings: Update iPrint3D PETG based on use) |
(→Recommended Filament Settings: update based on use) |
||
| Line 46: | Line 46: | ||
* Retraction Distance: 0.5 mm | * Retraction Distance: 0.5 mm | ||
* Retraction Speed: 30 mm/s | * Retraction Speed: 30 mm/s | ||
* Retraction Extra Prime Amount: | * Retraction Extra Prime Amount: 5.0 mm<sup>3</sup> | ||
'''Speed''' (Testing in progress on these settings) | '''Speed''' (Testing in progress on these settings) | ||
* Print Speed: 40 mm/s | * Print Speed: 40 mm/s | ||
** Infill Speed: | ** Infill Speed: 40 mm/s | ||
** Wall Speed 20 mm/s | ** Wall Speed 20 mm/s | ||
*** Outer Wall Speed: 20 mm/s | *** Outer Wall Speed: 20 mm/s | ||
*** Inner Wall Speed: 40 mm/s | *** Inner Wall Speed: 40 mm/s | ||
** Support Speed: | ** Support Speed: 40 mm/s | ||
* Travel Speed 240 mm/s | * Travel Speed 240 mm/s | ||
* Initial Layer Speed: 20 mm/s | * Initial Layer Speed: 20 mm/s | ||
| Line 68: | Line 68: | ||
NOTES: | NOTES: | ||
* If you are '''impatient''', then up any 20 mm/s setting to 25 mm/s. | * If you are '''impatient''', then up any 20 mm/s setting to 25 mm/s. | ||