Type A: Difference between revisions
Jump to navigation
Jump to search
→Recommended Filament Settings: note about aggressive PLA settings:
(→Recommended Filament Settings: note about aggressive PLA settings:) |
|||
| Line 33: | Line 33: | ||
'''CURA 3 settings for PLA by Filaments.ca'''<br /> | '''CURA 3 settings for PLA by Filaments.ca'''<br /> | ||
NOTE: 75mm/s is the fastest usable speed. If print finish/quality matters, then this might need to be reduced to 50mm/s, or even 25mm/s.<br /> | NOTE: The below settings for PLA are '''very aggresive''' -- for all those who can't wait for looong prints to finish. e.g. 75mm/s is the fastest usable speed. If print finish/quality matters, then this might need to be reduced to 50mm/s, or even 25mm/s.<br /> | ||
'''Quality''' | '''Quality''' | ||
* Layer Height: use anything from 0.1mm to 0.3mm | * Layer Height: use anything from 0.1mm to 0.3mm | ||