251
edits
3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
3D Printers/FlashForge Creator Pro (view source)
Revision as of 03:51, 12 January 2019
, 12 January 2019→Maintenance Log
| Line 276: | Line 276: | ||
| Jan 11, 2019 | | Jan 11, 2019 | ||
| Tightened X belt, and the small Y belt that connects the motor to the cross rod. Cleaned and lubricated all rods (X, Y, Z). Lubricated Z lead screw. Lubricated the rod bearings on the X and Y (including that the bearings for the cross rod that connects to two Y belts). Tightened the coupling on the Y axis stepper motor. | | Tightened X belt, and the small Y belt that connects the motor to the cross rod. Cleaned and lubricated all rods (X, Y, Z). Lubricated Z lead screw. Lubricated the rod bearings on the X and Y (including that the bearings for the cross rod that connects to two Y long belts). Tightened the coupling on the Y axis stepper motor. | ||
Prints were drifting (aka. leaning) towards the rear of the printer and it was driving me nuts. Turns out this can be due to a loose belt. The replicator and clones are susceptible the Y axis becoming loose because extra torque is outputted by the motor since it has to move the extruder carriage and the X stepper. | Prints were drifting (aka. leaning) towards the rear of the printer and it was driving me nuts. Turns out this can be due to a loose belt. The replicator and clones are susceptible the Y axis becoming loose because extra torque is outputted by the motor since it has to move the extruder carriage and the X stepper. | ||
I also removed some cobwebs from under the printer electronics. | |||
| Rana | | Rana | ||
|- | |- | ||