251
edits
3D Printers/Ender 5 plus: Difference between revisions
Jump to navigation
Jump to search
→Status
No edit summary |
(→Status) |
||
| Line 5: | Line 5: | ||
* '''Working - Read wiki instructions before use''' | * '''Working - Read wiki instructions before use''' | ||
* You must download the configs in the "Config" section below | * You must download the configs in the "Config" section below | ||
* Using the '''0.4mm layer height is recommended'''; it is hitting the max volumetric flow at this setting, using larger layer heights will not decrease print time significantly! Using smaller layer heights will though. | |||
* No filament runout sensor is installed. But one day it will be !! | * No filament runout sensor is installed. But one day it will be !! | ||
</onlyinclude> | </onlyinclude> | ||