251
edits
3D Printers/Ender 5 plus: Difference between revisions
Jump to navigation
Jump to search
→Status
(→Status) |
(→Status) |
||
| Line 4: | Line 4: | ||
<onlyinclude> | <onlyinclude> | ||
* '''Working - Read wiki instructions before use''' | * '''Working - Read wiki instructions before use''' | ||
* You must download the configs in the "Config" section below | * You must download the configs in the "Config" section below. The printer should be "set and forget", the touch probe and the bed mesh should give perfect first layers everytime. Still wipe the build plate with isopropyl though! | ||
* Using the '''0.4mm layer height is recommended'''; it is hitting the max volumetric flow at this setting, using larger layer heights will not decrease print time significantly! Using smaller layer heights will though. | * Using the '''0.4mm layer height is recommended'''; it is hitting the max volumetric flow at this setting, using larger layer heights will not decrease print time significantly! Using smaller layer heights will though. | ||
* No filament runout sensor is installed. But one day it will be !! | * No filament runout sensor is installed. But one day it will be !! | ||