3D Printers/Ender 5 plus: Difference between revisions

3D Printers/Ender 5 plus (view source)

34 bytes added , 20 August

251

edits

@@ Line 125: / Line 125: @@
 * using the built in e-steps I got 137.85 steps/mm (this is in the firmware, in the slicer you just change the flow rate)
-* at 220C and using PLA, got a max volumetric flow rate of 17 mm^3/s (this is old, have not tested PLA with the 80W heater)
+* for PLA at 205C, use a max volumetric flow rate of 21 mm^3/s (using 80W heater)
-* at 250C and using PETG, got a max volumetric flow rate of 21 mm^3/s (using 80W heater)
+* for TPU at 220C, use a max volumetric flow rate of 10 mm^3/s (using 80W heater)
+* for PETG at 235C, use a max volumetric flow rate of 21 mm^3/s (using 80W heater)
 == Printable Upgrades ==