251
edits
3D Printers/Ender 5 plus: Difference between revisions
Jump to navigation
Jump to search
→Print bed usage
| Line 139: | Line 139: | ||
== Print bed usage == | == Print bed usage == | ||
The glass plate has | The stock glass plate with magnetic backing has been put on upside down and taped to the heat bed via Kapton tape. The removeable PEI spring sheet is then stuck on that magnetic sheet. | ||
Wait for the PEI sheet to cool before removing your prints, take it off the bed and it will cool faster. PETG can rip off the PEI coating if it too hot. | Wait for the PEI sheet to cool before removing your prints, take it off the bed and it will cool faster. PETG can rip off the PEI coating if it too hot. | ||
Advisable to set the bed temperature to 10 degree's hotter than usual, because the heat has to go through the glass sheet to the PEI sheet. The +10 degrees are already incorporated into the print settings uploaded here. | |||
There is an insulating sheet on the left side of the printer. | |||
== SD Card == | == SD Card == | ||