Type A: Difference between revisions
Jump to navigation
Jump to search
→Recommended Filament Settings: Update iPrint3D PETG based on use
(→Machine Log: update for what done last week) |
(→Recommended Filament Settings: Update iPrint3D PETG based on use) |
||
Line 44: | Line 44: | ||
* Diameter: 1.75 mm | * Diameter: 1.75 mm | ||
* Flow: 100 % | * Flow: 100 % | ||
* Retraction Distance: 0. | * Retraction Distance: 0.5 mm | ||
* Retraction Speed: 30 mm/s | * Retraction Speed: 30 mm/s | ||
* Retraction Extra Prime Amount: 3.0 mm<sup>3</sup> | |||
'''Speed''' (Testing in progress on these settings) | '''Speed''' (Testing in progress on these settings) | ||
* Print Speed: | * Print Speed: 40 mm/s | ||
* Infill Speed: | ** Infill Speed: 50 mm/s | ||
* Wall Speed 20 mm/s | ** Wall Speed 20 mm/s | ||
** Outer Wall Speed: 20 mm/s | *** Outer Wall Speed: 20 mm/s | ||
** Inner Wall Speed: | *** Inner Wall Speed: 40 mm/s | ||
** Support Speed: 50 mm/s | |||
* Travel Speed 240 mm/s | * Travel Speed 240 mm/s | ||
* Initial Layer Speed: 20 mm/s | * Initial Layer Speed: 20 mm/s | ||
Line 63: | Line 65: | ||
'''Special Modes''' | '''Special Modes''' | ||
* Print Sequence: One at a Time | * Print Sequence: One at a Time | ||
NOTES: | |||
* If you are '''impatient''', then up any 20 mm/s setting to 25 mm/s. | |||
* If the infill or supports looks "really rough", then reduce the 50 mm/s settings to 40 mm/s. | |||