Type A: Difference between revisions
Jump to navigation
Jump to search
→Recommended Filament Settings: Additional Updates for PETG
(→Recommended Filament Settings: Additional Updates for PETG) |
|||
Line 39: | Line 39: | ||
'''Shell''' | '''Shell''' | ||
* Wall Thickness: 1.2 mm (3 perimeters seem to work a bit better than 2) | * Wall Thickness: 1.2 mm (3 perimeters seem to work a bit better than 2) | ||
* Top/Bottom Thickness: 1.2 mm (Same as above. | * Top/Bottom Thickness: 1.2 mm (Same as above. Requires more than for PLA.) | ||
* Top/Bottom Pattern: Zig Zag | |||
'''Infill''' | '''Infill''' | ||
* Infill Pattern: Zig Zag | * Infill Pattern: Zig Zag | ||
Line 71: | Line 72: | ||
'''Cooling''' | '''Cooling''' | ||
* Enable Print Cooling: UNSELECTED | * Enable Print Cooling: UNSELECTED | ||
* Minimum Layer Time: 10 S | |||
'''Special Modes''' | '''Special Modes''' | ||
* Print Sequence: One at a Time | * Print Sequence: One at a Time |