Ultimaker 2: Difference between revisions

Jump to navigation Jump to search
→‎Status: died mid-print
(→‎Status: died mid-print)
Line 8: Line 8:
Black PLA/PHA Filament to print parts for "Mother of all Cable Racks" Project.
Black PLA/PHA Filament to print parts for "Mother of all Cable Racks" Project.
*'''Last known good settings''': (28-Sept-2017, PLA/PHA)  '''220°''', 110% flow, print @ '''30mm/s''' (1/2 speed), travel @ '''60mm/s''' (also 1/2 speed), 0.4 mm nozzle size, 2.85mm filament size.
*'''Last known good settings''': (28-Sept-2017, PLA/PHA)  '''220°''', 110% flow, print @ '''30mm/s''' (1/2 speed), travel @ '''60mm/s''' (also 1/2 speed), 0.4 mm nozzle size, 2.85mm filament size.
* Operational ... it can be '''Problematic'''
* '''DOWN''' ... just DIED (no front Red LED) mid-print.
** Using a Brim to hold parts to the Print Bed is strongly recommended.
** Using a Brim to hold parts to the Print Bed is strongly recommended.
** Bed was leveled but Print Bed is NOT perfectly flat! (Back/Right corner worst.)
** Bed was leveled but Print Bed is NOT perfectly flat! (Back/Right corner worst.)
283

edits

Navigation menu