Search results

...read maker mysteriously showed up at the Nov 2022 JID. I recommend looking up recipes for it specifically from the menu; as the ones in the food section ...

The Original(?) Hacklab breadmaker. Look up some recipes! ...

* '''Ham-it-up SDR Up Converter''' (SDR Receiver HF Upconveter ...

...l T-Key] has been made which is now the ''only'' required tool for opening up both the main body and the cash drawer. It's attached with a string. ** Triggered when handset is picked up. ...

...ou send a print job and it doesn't print, you may have to wake the printer up ("Energy Saver" button on the top right). ...

A compilation of recipes that our members have come up with, or otherwise decided that should be shared among the membership. ...Delicious" status. Perhaps bump up to 475 next time, or bump minimum time up to 40/cycle. ...

No drivers should be required, plug into USB and it shows up as two sound devices, Speaker and Microphone. ...

...e is plugged in), the cut head will move back and forth and fans will spin up. # Flip up the clips and place them over top of the rollers near the cutting surface ...

...ddle of the surface. This is not as important unless your model will take up the entire surface, as models should be centered in the surface by skeinfor # The first time you run ReplicatorG you will have to set it up: Go to the "Machine" menu, and pick "Cupcake CNC" under the "Driver" submen ...

...touch by turning off the printer, *grabbing the probe tip*, and forcing it up and down a few times. ...

Currently, the working Ultimakers are hooked up to RaspberryPis sitting on the 3D Printer rack in The Hub, next to the Shop ...ve the bed out of the way by clicking on the Control tab and pushing the Z up arrow twice (if set to 10), so you can remove the half-printed model. '''In ...

There are 3 buttons; "SET", "UP ARROW", "DOWN ARROW". ...

* two temporary memberships per year are allowable, for up to a month each, per visitor ...

The ultimaker which was paid for by the membership is presently hooked up to a RaspberryPi accessible over SSH (see [[Ultimaker Operation Manual]]) ...o the cable coming loose at the hot end side and allowing plastic to build up at the top of the extruder and requiring disassembly to put it back in work ...

* Wait up to 10s for now. ...

* One mixed-up litre is good for exactly 12 rolls of ISO 400+ film. ...ts came out great, then there was an hour delay due to other things coming up, then we did two prints that were very dark and very low contrast no matter ...

...0. It's sd-card reader is busted, so this seemed the easiest way to get it up and running again. ...

* The Card is done up as a 90s era PC BIOS boot sequence that then loads to a UNIX link operating ...

* It has an improved heads up display of all the important printer stats (temp / target temp / percent co ...at the lab. Select a printer from the list (or hit enter if only one shows up) and your in. ...

I ended up figuring out a strategy though! If I advanced the tool position (radius of I heated it up with the Propane torch, let it slide down the mandrel, tapped it a few time ...